ZyXEL Communications XGS-4528F, User Manual, Page: 313 / 491

Chapter 32 Error Disable
XGS-4526/4528F/4728F User’s Guide
313
32.6 Error-Disable Recovery Configuration
Use this screen to to configure the Switch to automatically undo an action after
the error is gone. Click the Click Here link next to Errdisable Recovery in the
Advanced Application > Errdisable screen to display the screen as shown.
Figure 151 Advanced Application > Errdisable > Errdisable Recovery
The following table describes the labels in this screen.
Table 106 Advanced Application > Errdisable > Errdisable Recovery
LABEL DESCRIPTION
Active Select this option to turn on the error-disable recovery function on the
Switch.
Reason This field displays the supported features that allow the Switch to shut
down a port or discard packets on a port according to the feature
requirements and what action you configure.
* Use this row to make the setting the same for all entries. Use this row
first and then make adjustments to each entry if necessary.
Note: Changes in this row are copied to all the entries as soon as you
make them.
Timer Status Select this option to allow the Switch to wait for the specified time
interval to activate a port or allow specific packets on a port, after the
error was gone. Deselect this option to turn off this rule.
Interval Enter the number of seconds (from 30 to 2592000) for the time interval.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.