ZyXEL Communications VES-1616F-44, User Manual

Page: 229 / 296

VES-1616F/1624F-44 User’s Guide
228 Chapter 32 Introducing the Commands
32.11.4 interface Commands
The following table lists the
interface port-channel
commands in configuration mode.
Use these commands to configure the ports.
vlan1q gvrp
Enables GVRP. 13
port
Enables port isolation on the
systems.
13
port isolation
Enables VLAN port isolation on
all ports.
13
port isolation <port
number>
Enters the VLAN port isolation
mode to configure settings on
the specified port(s).
13
egress set <port-
list>
Enables egress port isolation
on the specified port(s).
13
exit
Exit from the port isolation
configuration mode.
13
no egress set
<port-list>
Disables egress port isolation
on the specified port(s).
13
vlan-stacking
Enables VLAN stacking on the
device.
13
<SPTPID>
Sets the service provider’s TP
(Tagged Protocol) ID.
13
vlan-type <802.1q|port-based>
Specifies the VLAN type. 13
wfq
Sets the switch to use Weight
Fair Queuing (WFQ) queuing.
13
Table 84 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION P
Table 85 interface port-channel Commands
COMMAND DESCRIPTION P
interface port-
channel <port-
list>
Enables a port or a list of ports for
configuration.
13
bandwidth-
limit
Enables bandwidth control on the
port(s).
13
egress <Mbps>
Sets the maximum bandwidth allowed
for outgoing traffic on the port(s).
13
ingress <Mbps>
Sets the maximum bandwidth allowed
for incoming traffic on the port(s).
13
bpdu-control
<peer|tunnel|d
iscard|network
>
Sets how Bridge Protocol Data Units
(BPDUs) are used in STP port states.
13
broadcast-
limit
Enables broadcast storm control limit
on the switch.
13