ZyXEL Communications VES-1616F-44, User Manual

Page: 125 / 296

VES-1616F/1624F-44 User’s Guide
124 Chapter 17 Access Control
Figure 56 Access Control: SNMP
The following table describes the labels in this screen.
17.3.4 Configuring SNMP Trap Groups
Use the Trap Group screen to set which traps the switch sends to each trap destination.
From the Access Control screen, display the SNMP screen. Then click Trap Group . You can
click SNMP Setting to go back to the SNMP screen.
Figure 57 Access Control: SNMP: Trap Group
Table 47 Access Control: SNMP
LABEL DESCRIPTION
Get Community Enter the get community, which is the password for the incoming Get- and GetNext-
requests from the management station.
Set Community Enter the set community, which is the password for incoming Set- requests from the
management station.
Trap Community Enter the trap community, which is the password sent with each trap to the SNMP
manager.
Trap Destination Enter the IP addresses of up to four stations to send your SNMP traps to.
Apply Click Apply to save your changes back to the switch.
Cancel Click Cancel to begin configuring this screen afresh.