ZyXEL Communications Prestige 128L, User Manual

Page: 30 / 114

18 Installation
Figure 3-2 Front Panel
PWR - Comes on as soon as you connect your Prestige to the power
supply and switch it to the I (on) position.
TST - Should be blinking if your Prestige is functioning properly.
Line: LNK - Indicates that your Prestige has an ISDN line connected
to the WAN interface and it has been successfully initialized.
64K and 128K - The 64K LED will light to indicate a line speed of
64K. The 64K and 128K LED will light to indicate a line speed of
128K.
Ethernet: LNK - Indicates that the Prestige has been successfully
connected to the LAN via the Ethernet interface.
TX and RX - Transmit and Receive LEDs will blink to indicate when
there is traffic on the LAN.
COL - Indicates that there is transmission collision over the LAN.
SMT - Indicates your Prestige is connected to a terminal emulator via
the RS-232 port.
SERVER - Indicates your Prestige is configured as a server.
Powering On Your Prestige
When you power on your Prestige, it will perform several internal tests
and will also do an IDSL line initialization. After this initialization, your
Prestige will ask you to press
ENTER to continue as shown below: