ZyXEL Communications PLA-402 v3, User Manual

Page: 83 / 94

Chapter 9 LEDs and Troubleshooting
PLA-402 v3 User’s Guide
83
• Wait for about a minute while the devices set up a connection.
• If that does not work, try again with both devices connected to a power strip
next to each other. If they now connect, then the devices were not on the same
electrical circuit before.
The POWER lights on both devices blink, then many lights blink and the
HomePlug light blinks red.
Do not worry, the connection process is proceeding normally.
The POWER lights on both devices finished blinking, but only one device’s
HomePlug light is on.
One device may have connected to a third coaxial device. To check device A is
connected to device B and not another device, disconnect device B from its power
source. Device A’s HomePlug (
) light will turn off if the connection is with
Device B. Press the SETUP button on both devices for more than 10 seconds,
then try to reconnect, pressing the SETUP button for less than 3 seconds on both
devices.
I pressed the SETUP button for more than 10 seconds, but the HomePlug light is
still on.
The HomePlug light is on, indicating it is still connected to another coaxial device.
Try again, pressing the
SETUP button for more than 10 seconds.