ZyXEL Communications PLA-402 v3, User Manual

Page: 30 / 94

Chapter 4 The SETUP Button
PLA-402 v3 User’s Guide
30
4
Press the SETUP button at the side of your coaxial device for 1~2 seconds. The
power ( ) light will blink as the PLA-402 v3 tries to set up a connection.
Figure 9 SETUP Connection Procedure
Note: The SETUP button’s location varies for each coaxial device.
5
Repeat step 4 in this section for the other coaxial device you wish to connect. This
must be done within 120 seconds of pressing the SETUP button on the PLA-402
v3.
6
Check the lights on the two coaxial devices. The power ( ) and HomePlug ( )
lights should be blinking while the devices are connecting. Several times all lights
blink simultaneously and the HomePlug (
) light also shows red. Wait for about
one minute while your coaxial devices connect.
If the power ( ) light does not blink when you press SETUP , you have probably
pressed the SETUP button for too long. Try again, pressing the SETUP button for
1~ 2 seconds.
If the HomePlug ( ) lights on both coaxial devices do not light up, the coaxial
devices are not connected. Repeat steps 4 and 5 in this section. If that doesn’t
work, see the Troubleshooting in Section 9.5 on page 82 for suggestions.
7
To add more coaxial devices to your network, press the SETUP button on device C
(shown below) for more than 10 seconds until the power ( ) light flashes.
within 2 minutes
press for
2 seconds
press for
2 seconds