ZyXEL Communications P-661H-61, Manual, Page: 184 / 404

Chapter 10 Quality of Service (QoS)
P-661HNU-Fx User’s Guide
184
Classification
Order Select an existing number for where you want to put this classifier to
move the classifier to the number you selected after clicking Apply.
Select Last to put this rule in the back of the classifier list.
Forward to
Interface Select a WAN interface through which traffic of this class will be
forwarded out. If you select Unchange, the ZyXEL Device forward
traffic of this class according to the default routing table.
DSCP Mark This field is available only when you select the Ether Type check box
in Criteria Configuration-Basic section.
If you select Mark, enter a DSCP value with which the ZyXEL Device
replaces the DSCP field in the packets.
If you select Unchange, the ZyXEL Device keep the DSCP field in the
packets.
To Queue Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen
already.
Criteria Configuration
Use the following fields to configure the criteria for traffic classification.
Basic
From Interface
Select whether the traffic class comes from the LAN or a wireless
interface.
Ether Type Select a predefined application to configure a class for the matched
traffic.
If you select IP, you also need to configure source or destination MAC
address, IP address, DHCP options, DSCP value or the protocol type.
Source
MAC Address Select the check box and enter the source MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits
a packet’s MAC address should match.
Enter “f” for each bit of the specified source MAC address that the
traffic’s MAC address should match. Enter “0“ for the bit(s) of the
matched traffic’s MAC address, which can be of any hexadecimal
character(s). For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a
MAC address of 00:13:49:12:34:56 matches this criteria.
IP Address Select the check box and enter the source IP address in dotted
decimal notation. A blank source IP address means any source IP
address.
IP Subnet
Mask
Enter the source subnet mask.
Port Range If you select TCP or UDP in the IP Protocol field, select the check
box and enter the port number(s) of the source.
Exclude Select this option to exclude the packets that match the specified
criteria from this classifier.
Destination
Table 41 Class Setup: Add/Edit (continued)
LABEL DESCRIPTION