ZyXEL Communications P-2601HN(L)-F1 Series, User Manual

Page: 128 / 344

Chapter 8 Routing
P-2601HN(L)-F1 Series User’s Guide
128
8.2 Configuring Static Route
Use this screen to view and configure IP static routes on the ZyXEL Device. Click
Network Setting > Routing to open the following screen.
Figure 54 Network Setting > Routing
The following table describes the labels in this screen.
Table 24 Network Setting > Routing
LABEL DESCRIPTION
Add New
Static Route Click this to set up a new static route on the ZyXEL Device.
# This is the number of an individual static route.
Active This indicates whether the rule is active or not.
A yellow bulb signifies that this static route is active. A gray bulb signifies
that this static route is not active.
Status This shows whether the static route is currently in use or not. A yellow
bulb signifies that this static route is in use. A gray bulb signifies that this
static route is not in use.
Name This is the name that describes or identifies this route.
Destination IP This parameter specifies the IP network address of the final destination.
Routing is always based on network number.
Gateway This is the IP address of the gateway. The gateway is a router or switch
on the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
Subnet Mask This parameter specifies the IP network subnet mask of the final
destination.
Interface This is the WAN interface through which the traffic is routed.
Modify Click the Edit icon to go to the screen where you can set up a static route
on the ZyXEL Device.
Click the Delete icon to remove a static route from the ZyXEL Device.