ZyXEL Communications Dimension GS-3012F, User Manual

Page: 156 / 235

GS-3012F User’s Guide
23-4 Maintenance
23.7.1 Filename Conventions
The configuration file (often called the romfile or rom-0) contains the factory default settings in the screens such as
password, switch setup, IP Setup, etc. Once you have
customized the switch's settings,
they can be saved back to your computer under a filename of your choosing.
ZyNOS (ZyXEL Network Operating System sometimes referred to as the “ras” file) is the system firmware and
has a “bin” filename extension.
Table 23-1 Filename Conventions
FILE TYPE INTERNAL
NAME
EXTERNAL
NAME
DESCRIPTION
Configuration File config This is the configuration filename on the switch. Uploading the
config file replaces the specified configuration file system,
including your
switch configurations, system-related data
(including the default password), the error log and the trace log.
Firmware Ras *.bin This is the generic name for the ZyNOS firmware on the switch.
Example FTP Commands
ftp> put firmware.bin ras
This is a sample FTP session showing the transfer of the computer file " firmware.bin" to the switch .
ftp> get config config.cfg
This is a sample FTP session saving the current configuration to a file called “config.cfg” on your computer.
If your (T)FTP client does not allow you to have a destination filename different than the source, you will need to
rename them as the switch only recognizes “
config ” and “ras”. Be sure you keep unaltered copies of both files for
later use.
Be sure to upload the correct model firmware as uploading the wrong model firmware may
damage your device.
23.7.2 FTP Command Line Procedure
1.
Launch the FTP client on your computer.
2.
Enter “open”, followed by a space and the IP address of your switch.
3.
Press
[ENTER]
when prompted for a username.
4.
Enter your password as requested (the default is “1234”).
5.
Enter “bin” to set transfer mode to binary.
6.
Use “put” to transfer files from the computer to the switch, for example, “put firmware.bin ras” transfers
the firmware on your computer (firmware.bin) to the switch and renames it “ras”. Similarly, “put
config.
cfg config ” transfers the configuration file on your computer (config. cfg ) to the switch and