ZyXEL Communications Dimension ES-3024, User Manual, Page: 115 / 212

Dimension ES-3024 Ethernet Switch
14-4 Link Aggregation
14.3 Link Aggregation Setup
Click Configuration in the Link Aggregation Protocol Status screen to display the screen shown next.
Figure 14-3 Link Aggregation: Configuration
The following table describes the labels in this screen.
Table 14-3 Link Aggregation: Configuration
LABEL DESCRIPTION
Link Aggregation Control Protocol
Active Select this checkbox to enable Link Aggregation Control Protocol (LACP).
System Priority LACP system priority is a number between 1 and 65,355. The switch with the lowest system
priority (and lowest port number if system priority is the same) becomes the LACP “server”.
The LACP “server” controls the operation of LACP setup. Enter a number to set the priority
of an active port using Link Aggregate Control Protocol (LACP). The smaller the number,
the higher the priority level.
Index The index identifies the link aggregation group, that is, one logical link containing multiple
ports
Active Make sure to select this check box to activate the trunk group. You may temporarily
deactivate a trunk group without deleting it by clearing this check box.
Starting Port This is the beginning port in the trunk group’s port range and is not configurable - see Table
14-1 .
Ending Port Select the end port in the port range from the drop-down list box – see Table 14-1 .
LACP Select this check box to enable LACP for a trunk.