FCC Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Industry Candata (IC) Warning:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicable aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
The following information refers to Zurn Smart Connected Products.
Radiation Exposure Statement:
To comply with FCC and Industry Canada RF exposure limits for general population / uncon-
trolled exposure, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 30mm from
all persons and must not be operating in conjunction with any other antenna or transmitter, except in accordance with FCC
multi-transmitter product procedures.
FCC Interference Statement:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
intended for use in non-residential/non-domestic environments. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult an authorized dealer or service representative for help.
Zurn is not responsible for any radio or television interference caused by using other than specified or recommended cables and
connectors or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the
user's authority to operate the equipment.
Responsible party:
ZURN INDUSTRIES, LLC
511 W. Freshwater Way, Milwaukee, WI U.S.A. 53204
Ph.
1-855-ONE-ZURN
, Fax 919-775-3541
Electronic Emission Notices
ZURN WILKINS
1747 Commerce Way, Paso Robles, CA 93446 Phone:855-663-9876 Fax:805-238-5766
4
www.zurn.com
Testing
To check accuracy of pressure readings: Install a calibrated pressure gauge in the test port. Read gauge. Power cycle the
ZCSM-RP by unplugging and plugging the power cord back in. After five minutes, a new pressure reading should be available on
the portal. Compare pressure reading on portal to pressure gauge. If a system shutoff valve is installed between the pipe line and
the ZCSM-RP, you can close this valve, then open the test cock to bleed pressure down to zero. Now power cycle the ZCSM-RP.
Verify the new pressure reading on the portal is zero psi +/- 4psi.
Maintenance
If the ZCSM-RP is connected to a test port or other area in plumbing system that may accumulate debris, flush the affected zone at
least once per year. If you encounter a lot of debris or rust, increase the frequency of flushing.
