Install Zurn Gateway
Once you've received your Zurn Gateway, please follow the steps below for installation. More detailed instructions are also
included with your Zurn Gateway.
1. Choose a location that is within 1000 feet of the Zurn Connected Product(s) you're installing. Typically, your building's walls
should not be an issue. However, be sure to avoid major obstructions, such as thick concrete walls or metal reflective surfaces
that will weaken the signal reception.
2. As with any electronic or networking device, install your Zurn Gateway in a cool, dry, dust-free location. In general, air condi-
tioned offices or server rooms work best.
3. Make sure you have access to a standard 120V electrical outlet to plug in your Zurn Gateway.
4. Then, depending on your choice of gateway, please follow the instructions below.
Ethernet LAN
STEP 1: Plug the power cord into the electrical outlet to power up your gateway.
STEP 2: If the network is secured, ask your network administrator to authorize this gateway. You can provide the MAC address for
the gateway, which is printed on the bottom of the label.
STEP 3: Confirm the status of the two LED indicators (Status and LoRa) to complete your setup.
• Status LED double-flashes green every two seconds
• LoRA LED is ON (solid green) two minutes after being powered
LTE Cellular
STEP 1: Check that the location isn't obstructed for sending and receiving cellular signals. You can use your own AT&T cellular
device's connectivity as an indicator.
STEP 2: Once location is confirmed, plug the power cord into the electrical outlet.
STEP 3: Confirm the status of the three LED indicators (Status, LoRa and Cell) to complete your setup.
• Status LED double-flashes green every two seconds
• LoRA LED is ON (solid green) two minutes after being powered
• Cell LED is ON (solid green) two minutes after being powered
Request and Install Your Zurn Gateway
Call Before You Install Your ZCSM-RP Connected Remote Pressure Monitor
If you already have a Gateway installed and access to plumbSMART™, skip to Install Your ZCSM-RP Connected
Remote Pressure Monitor section.
1. Document the serial number from the label on the backside of your ZCSM-RP Connected Pressure Monitor.
2. Visit www.zurn.com/plumbSMART-connect to save time and money on your installation. You can also call us at 844-987-6737.
3. Provide the serial number and contact name, email address, and basic information about the installation site.
4. We will activate your plumbSMART™ account, set up your enterprise, and give you guidance on how to register each
connected product as you install it.
5.
We will send a confirmation email with a link, or you can go to plumbsmart.zurn.com to log into your plumbSMART™ account
for the first time.
6. Add other users and installers to your plumbSMART™ account.
7. Make sure you and/or your installers have the plumbSMART™ mobile app, which you can download from the iPhone App
Store or Google Play.
8. Using the mobile app, scan or enter the serial number to register and locate each connected plumbing product as you install it.
9. Watch the how-to videos in the plumbSMART™ portal's support section if you get stuck, or call us at 844-987-6737 for support.
ZURN WILKINS
1747 Commerce Way, Paso Robles, CA 93446 Phone:855-663-9876 Fax:805-238-5766
2
www.zurn.com
