41
EN
Fault
Possible cause
Correction
The faucet gets blocked
The juice has seeds or too much
pulp.
Disassemble and clean the
faucet according Fig. 11A.
The machine stops every
now and again
Insufficient ventilation.
Check that the appliance’s
ventilation grilles are not
blocked.
Overload.
Contact your technical service.
Screen does not display
information
Alteration to mains systems.
Turn off the machine and turn it
back on again.
The machine is in self-
service mode and won’t
stop operating
Faucet not fitted or fitted
incorrectly.
Fit the faucet in the manner
indicated in Fig. 11A
Faucet well fitted: possible
internal fault.
Contact your technical service.
Faucet block activated.
Put the block in horizontal
position by pressing the faucet
downwards.
The sweeper motor does
not turn
Pulp-out deactivated
Activate the PulpOut in
continuous or intermittent
mode
Check that the PulpOut system
is active
Notify Technical Service
WARNING:
Any action to unblock the machine must be carried out
by disconnecting it from the mains. If, after making the checks stated here, the
machine does not work, call the technical service.
Screen Messages
*The message:
“Keyboard error” may not appear on the display as there is no communication between the
CPU and the keyboard panel
Display Message
Cause
Correction
Excess current
The maximum electrical
consumption level has been
exceeded for at least one
second.
Turn off at mains and turn
back on again.
No oranges
The motor remains on for
two minutes detecting any
squeezing.
Put oranges back in feeder
again without and press ON.
Memory initiated
A memory error has been
detected.
Contact your technical service.
Calibration
An incorrect calibration value
has been detected.
Calibrate.
Out of service
The counter has reached zero.
Modify the discounter value as
indicated in page 21 or move
on to counter function entering
PARTIAL COUNTER and
pressing ON.
Eeprom
Error detected in EEPROM
memory.
Contact your technical service.
Out of range
The input power voltage is
less than 80V or greater than
260V.
Contact your technical service.
Keyboard error (error 1)
No communication with the
keyboard (Internal fault).
Contact your technical service.
Juice tray picture flashing
Check the juice tray and front
cover are placed correctly.
Place the tray and cover in its
correct position as Fig. 4. If the
picture does not disappear,
contact your technical service.
Waste limit
Waste bucket full according to
the oranges specified.
Empty the waste bucket and
clean the machine.
