9. Switching Frequency
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
d. When you hear // // // // means you are in the Switching Frequency menu, please choose
your desired value by pulling the throttle stick to the lowest position.
e. The system will exit automatically and save the setting after nishing the desired item. You
only can setup one item at a time, if you want to program another item you need unplug the
battery and power on the ESC again.
8kHz
– In runner motor recommended
16kHz
– out-runner motors recommended
10 Low Voltage Cutoff Type
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
d. When you hear
＿
ˉ
＿
ˉ
＿
ˉ
＿
ˉ means you are in the Low Voltage Cutoff Type menu,
please choose your desired value by pulling the throttle stick to the lowest position.
e. The system will exit automatically and save the setting after nishing the desired item. You
only can setup one item at a time, if you want to program another item you need unplug the
battery and power on the ESC again.
Reduce Power
– Lower the power output
Hard Cutoff
– Immediately shut down the power once the voltage reaches the preset value
e. The system will exit automatically and save the setting after nishing the desired item. You
only can setup one item at a time, if you want to program another item you need unplug the
battery and power on the ESC again.
There are two way to change the motor rotation:
a) by swapping any two motor wires
b) by programming with program box or radio.
6
8. Motor Rotation: Forward/ Reverse
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
d. When you hear W W W W means you are in the Motor Rotation menu, the default setup
is OFF, please choose your desired value by pulling the throttle stick to the lowest position.
