e. The system will exit automatically and save the setting after nishing the desired item. You
only can setup one item at a time, if you want to program another item you need unplug the
battery and power on the ESC again.
1)
For Li-xx packs- number of cells are automatically calculated and requires no user input
apart from dening the battery type. This ESC provides 3 setting options for the low voltage
protection threshold ; Low (2.8V)/ Medium (3.0V)/ High (3.2V). For example : the voltage
cutoff options for an 11.1V/ 3 cell Li-Po pack would be 8.4V (Low)/ 9.0V(Med)/ 9.6V(High)
2)
For Ni-xx packs-low / medium / high cutoff voltages are 50%/60%/65% of the initial
voltage of the battery pack.. For example: A fully charged 6 cell NiMh pack's voltage is 1.44V
x 6=8.64V,when “LOW” cutoff voltage is set, the cutoff voltage is: 8.64V x 50%=4.3V and
when “Medium” of “High” is set, the cutoff voltage is now 8.64V X 65%=5.61V.
4. Factory Setup Defaults:
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
d. When you hear “— — — —“ means you are in the Factory Setup Defaults menu, please
choose your desired value by pulling the throttle stick to the lowest position.
e. The system will exit automatically and save the setting after nishing the desired item. You
only can setup one item at a time, if you want to program another item you need unplug the
battery and power on the ESC again.
Restore- Sets the ESC back to factory default settings;
Brake
：
OFF
Battery type Detect
：
LiPo with Automatic Cell
Low voltage Cutoff threshold
：
Medium (3.0V/60%)
Timing Setup
：
Automatic
Acceleration
：
Soft Acceleration
Governor Mode
：
RPM OFF
Frequency
：
8kHz
Low Voltage Cutoff Type
：
Reduce power
5. Timing Setup
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
d. When you hear – – – – means you are in the Timing Setup menu, please choose your
desired value by pulling the throttle stick to the lowest position.
4
