Using the ESC
1. Turn on your radio and keep the throttle stick to the lowest position
2. Connect the battery pack to the ESC.
3. Motor emits two sets of audible tones in succession means the ESC is armed and ready to
use. The rst set of tone counting the cells of the battery the second set of means the status of
the brake setting.
Entering the programming Mode
1. Turn on your radio and set the throttle stick to top positon (100%)
2. Plug the battery pack into your controller
3. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
Programmable Items
1. Brake
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
d. When you hear _ * _ * _ * _ * means you are in the Brake menu, the default setup is OFF,
if you want to turn on the brake pull the throttle stick to the lowest position.
e. The system will exit automatically and save the setting after nishing desired item. You
only can setup one item at a time, if you want to program another item you need unplug the
battery and power on the ESC again.
2. Battery Type : NiCad/NiMH/LiPo
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
d. When you hear
～
～
～
～
means you are in the Battery Type menu, please choose your
desired value by pulling the throttle stick to the lowest position.
e. The system will exit automatically and save the setting after nishing desired item. You
only can setup one item at a time, if you want to program another item you need unplug the
battery and power on the ESC again.
3. Low Voltage Protection Threshold ( Cutoff Threshold )
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
d. When you hear *_ _* *_ _* *_ _* *_ _* means you are in the Low Voltage Protection
Threshold menu, please choose your desired value by pulling the throttle stick to the lowest
position.
3
