30
31
5. Set peer AP's wire
-
less MAC address on
router
Only
Repeater Mode
and
Bridge Mode
need this.
The HT physical Mode parameters are shown below:
•
Operating Mode
: In
Mixed Mode
, packets are transmitted with
a preamble compatible with the legacy 802.11a/g, the rest of
the packet has a new format. In
Green Field
, high throughput
packets are transmitted without a legacy compatible part.
•
Channel BandWidth
: Set the HT physical channel bandwidth.
•
Guard Interval
: Guard interval is to introduce immunity to
propagation delays, echoes and reflections, to which digital data
is normally very sensitive.
•
MCS
: The Modulation and Coding Scheme (MCS) is a value
that determines the modulation, coding and number of spatial
channels.
•
Reverse Direction Grant(RDG)
: Enable
RDG
or not.
•
Extension Channel
: Set extension channel. Extension channel
is also able to send and receive data.
•
Aggregation MSDU(A-MSDU)
:To enable Hyper Throughput TX
Aggregate MAC Service Data Unit, select
Enable
.
•
Auto Block ACK
: Select to block ACK (Acknowledge Number)
or not during data transferring.
•
Decline BA Request
: Select to reject peer BA-Request or not.
Click
Apply
to confirm your configuration.
Advanced
Select
Wi-Fi Setting > Advanced
, the advanced wireless network
parameters are shown in the following figure:
•
Beacon Interval
: The router broadcasts beacon message to
announce that it has buffered frames to deliver. The default value
is 100 (ms).Beacons are packets sent by an access point to
synchronize a wireless network. Specify a beacon interval value.
is recommended.
•
Data Beacon Rate(DTIM)
: A Delivery Traffic Indication
Message(DTIM) informs next clients to listen to broadcast and
multicast messages.
•
Fragment Threshold
: This value should remain at its default
value of 2346. If you experience a high packet error rate, you
may slightly increase your fragment threshold. Setting the
fragment threshold too low may result in poor performance.
•
RTS Threshold
: Request To Send (RTS) threshold should be
remained as the value of 2347. If you encounter inconsistent
data flow, only minor modifications are recommended.
•
TX Power
: Transmit power should be remained as the value of
100.
•
Short Preamble
: The length of CRC block in the frames during
the wireless communication.
MF29T User Manual V1.1-0703.indd 30-31
2012-7-3 16:46:32
