56
ADAPTATION TO THE PWC
To connect the Jet Pack by ZR on the watercraft:
a) Remove the steering and reverse systems.
b) Assemble the pump interface (ref. FB03A08) with the appropriate adapter (PWC brand and model specific).
Adaptors are necessary for to allow assembly between the Jet Pack by ZR and the PWC. They are available through the distribution network, and
compatible with all main brands: Sea Doo, Yamaha, Kawasaki and Honda. As the adaptor is not included in the Jet Pack by ZR, please ensure your
dealer know which PWC brand and model you intend to use with the Jet Pack by ZR.
Adapting the Jet Pack by ZR on Sea Doo Spark:
A specific adaptation system is available for the use of the Jet Pack by ZR with the Sea Doo Spark (2 or 3 seaters, with or without IBR, recommended
for 90HP version). Please refer to page 18 for complete assembly instructions.
WHERE TO PRACTICE JET PACK BY ZR?
The Jet Pack by ZR can be used in both lakes and open seas when the minimum water depth of 4 meters is respected.
It is strictly forbidden to use the Jet Pack by ZR in confined spaces such as swimming pools etc...
Do not start the watercraft or use the Jet Pack by ZR in insufficient water depths (less than 1 meter) with sandy bottom, it may damage the Jet Pack
by ZR bearings.
In the event of such use, check the operation of all bearings before further use to avoid breakage of the equipment.
Warning, it is the responsibility of the user to make sure there is sufficient depth in the stretch of water used.
MAINTENANCE – AFTER SALES SERVICE
WARNING: NEVER use hydrocarbons like acetone or petrol on polycarbonate parts (all see-through parts) as these products
can seriously damage the material.
To ensure adequate security, we recommend to:
• Check the all seat’s screws are tight after 2 hours of use.
• Change the supply hose every 2 years.
•Change the plastic balls ref. FB02267 of the Jet Pack by ZR seat ref. FB04B01 every year. Ensure to use silicone grease or Vaseline (no marine
grease or other product containing hydrocarbons that may damage the Jet Pack by ZR material).
• Change the clips ref. FB02046 of the Jet Pack by ZR seat ref. FB04B01 every year.
• Change the rings ref. FB04070, FB04071, FB04087, FB04094 and FB03011 every year.
•the Jet Pack by ZR should be rinsed with clean water after each use (hose, seat) and stored in a dry location away from direct sunlight (this does
not apply to the X-Armor hose ZR01003 / ZR01003-23).
• Do not pull the hose on the floor when full of water (this does not apply to the X-Armor hose ZR01003 / ZR01003-23).
•The hose should be rinsed, dried and rolled up after each use and stored away from direct sunlight (this does not apply to the X-Armor hose
ZR01003 / ZR01003-23).
WARRANTY
The Jet Pack by ZR is covered by warranty against all manufacturing faults for 1 year following the date of purchase. You will
be required to provide your purchasing invoice.
ZAPATA RACING® will provide warranty cover on the Jet Pack by ZR if used as described in this manual.
Warranty is limited to the operation and not the visual condition of the parts.
Warranty does not cover any part subject to wear and tear (i.e. plastic balls ref. FB02267, hose (ref. FB02002 / ZR01002 / ZR01002-23, etc.)
the Jet Pack by ZR should be used in its original configuration. It is strictly forbidden and dangerous to modify, remove or add parts other than those
provided by ZAPATA RACING®.
Breakage of equipment caused by falls or violent/extreme use will not be covered by warranty.
