Zoom ISDN TA, Owner'S Manual, Page: 50 / 63

50 TA/V.34 and TA Owner’s Manual
Appendix D:
V.110 Configuration
This appendix provides further information on using V.110 as specified
on page 26.
The data rates under V.110 are controlled by S37 . The %B0 command
should be set to allow the DTE to auto-baud. It is the DCE rate that is
constrained by the V.110 protocol; it is determined by
S37 .
There are distinct V.110 inits, for each supported data rate. Listed
below are the AT commands for the three most common: 9600, 19200
and 38400 bps.
V.110 9600
AT&F%o0%A2=1 N0 %B0 S37=17
V.110 19200
AT&F%o0%A2=1 N0 %B0 S37=27
V.110 38400
AT&F%o0%A2=1 N0 %B0 S37=50
A complete list of possible values for S37 under V.110 is as follows:
5 1200 bps
6 2400
15 4800
16 7200
17 9600
18 12000
19 14400
27 19200
50 38400