Storing Patches and Banks (Store Mode)
ZOOM G9.2tt
30
1.
Turn power to the G9.2tt on while
holding down the [STORE/SWAP] key.
The indication "All Initialize?" appears on the
display.
2.
Press the [STORE/SWAP] key once
more.
All patches are returned to the factory default
condition, and the G9.2tt switches to play mode.
By pressing the [EXIT] key before performing
step 2, you can cancel the process.
All Initialize?
All Initialize?
Y:STORE N:EXIT
Y:STORE N:EXIT
ZOOM G9.2tt
31
Using the Expression Pedals
This section explains how to use the two built-in expression pedals of the G9.2tt.
About the expression
pedals
The G9.2tt comes standard with two expression
pedals that can be used to control specific effect
parameters in real time.
Expression pedal 1 on the left side has four
control targets (P1-1 to P1-4), and a parameter
can be assigned for each control target. This
makes it possible to adjust up to four parameters
of different modules simultaneously. A setting
example is shown below, to give you an idea of
how the pedal can be used.
Expression pedal 2 on the right side the Z-Pedal
that senses not only vertical but also horizontal
movement. It has four control targets in the
vertical direction (P2V1 to P2V4) and four
control targets in the horizontal direction (P2H1
to P2H4). A parameter can be assigned for each
control target.
With a setting such as shown in the example at
right, the pedal adjusts the Gain parameter of the
PRE-AMP module when moved in the vertical
direction and the Rate parameter of the MOD/
EFX2 module when moved in the horizontal
direction. It is also possible to control both at the
same time with one pedal.
HINT
• The parameter adjustment range covered by
expression pedals 1 and 2 can be set for each
control target separately.
• In bypass mode, both expression pedals
function as a volume pedal when moved in the
vertical direction. (Moving expression pedal 2 in
the horizontal direction has no effect.)
• In mute mode, both expression pedals have no
effect.
NOTE
Expression pedal 2 of the G9.2tt is designed for
operation with one foot. When the pedal is fully
turned to the right, pushing it strongly down, hitting
it, or otherwise exerting strong force on it will
damage the pedal. Be sure to operate the pedal
only within its designated range.
Gain
Rate
Feed Back
Mix
Expression
pedal-1
Control target parameters
PRE-AMP module
●
P1-1
MOD/EFX2 module
●
P1-2
DELAY module
●
P1-3
REVERB module
●
P1-4
Gain
Rate
Expression
pedal 2
Control target parameters
PRE-AMP module
●
P2V1
MOD/EFX2 module
●
P2H1
