Here is a picture of the
Static Routes
page:
The following table describes Routing Table settings. If you change
any of the settings, click
Add
, and then
Write Settings to Flash
.
Setting
Description
Existing Routes
This table shows the existing Static
routes set up on your ADSL Modem.
Destination
Enter the
Subnet IP address
of the
destination.
Gateway
Enter the
Gateway IP address
of your
destination’s subnet. The HOP gateway
must be on the same subnet as the
modem.
Mask
Enter the
subnet mask
(range of IP
addresses) of the destination IP
addresses based on the above subnet IP
address of the destination.
Metric
The number of hops.
This should
usually be left at 1
.
Advertise
Enable this if you want to advertise this
route.
Chapter 6: Using Router Setup
99