To activate the IP address filter:
1
Enter the last byte (the numbers after the last period) of the IP address in
Start Address
and
End Address
.
2
Check the
Enable
box to the right of the entry to store settings.
3
Click the
Apply
button to activate the filter rules.
Table 10. IP Filtering Menu Option
Option
Description
Start/End
Address
Enter the last byte of the IP address. The upper bytes of the IP address are set
automatically from the cable modem/router IP address.
Enable
To activate the IP address filter, you must also check the
Enable
box and click
Apply
. You can disable this filter while retaining the addresses you entered for
later use.
MAC Filtering
The MAC Filtering page allows you to configure MAC address filters in order to block Internet traffic
to specific network devices on your LAN.
To access the
MAC Filtering
page:
1
Click
Advanced
in the menu bar.
2
Then click the
MAC Filtering
submenu.
Figure 16 shows an example of the menu and Table 11 describes the items you can select.
44
Summary of Contents for 5350
