14
Wireless Modem User’s Manual
3
Typical PDA Installation
The basic steps associated with setting up your Bluetooth
wireless modem and your PDA include the following tasks:
•
Connect the hardware.
•
Set up Bluetooth for Dial-up Networking (DUN) and
establish a connection between the PDA and the modem.
•
Create a dial-up connection to the Internet.
Connect the Hardware
1
On the back of the modem, make sure the selectable switch is
all the way to the left, the side marked BT (for Bluetooth).
2
Plug one end of the supplied phone cord into the modem’s
Line port, and plug the other end into a telephone wall jack.
3
Plug one end of the included power adapter into the modem
and the other end into a wall outlet or power strip.
Note:
To establish a Bluetooth connection with your PDA and
this modem, your PDA must have built-in Bluetooth
capability or a Bluetooth flash adapter/cradle. You cannot
proceed with these instructions unless the Bluetooth
function is enabled. Tip: If Bluetooth is enabled, you will
see a Bluetooth entry in your Programs folder.
Set Up Dial-up Networking and Establish
Communication
1
1
1
1
Go to Start | Programs | Bluetooth Manager. From the list
of options, tap Dial-up Networking (DUN) and then
Enable DUN. Note: If you cannot bring up Bluetooth
