13-MUFFLER COMPONENT
89
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1244200-139000 ZT310 rubber buckle
（
120mm
）
1
2
1251100-061093 M6×22 Hex flang bolt thread level 8.8 (color zinc)
2
3
1251112-002093 M6×30 Hexagon flange bolts (color zinc)
1
4
1250205-023000 GB70.1 inner hexagonal M8X35 (color zinc)
1
5
1274100-074000 ZT310-R Muffler stainless steel bar clasp
1
6
1250205-125000 GB70.2 M8×35
（
12.9 grade,dacro
）
1
8
1124300-004000 ZT350
－
GK muffler graphite gasket
（
37.8×28×11
）
1
Fig.1 MUFFLER
COMPONENT
Muffler component 1
7
1020243-097000 ZT350 muffer flanging bushing
（
φ8.3×φ11.5×20.5×φ
8.4×φ33×1.5
）
1
PROCEDURE:
●
Muffler component
Remove the shroud assembly according to the step of "lower shroud assembly 1".
Referring to the steps in "Water tank decorative cover", remove the water tank decorative cover component
first.
Lower the side stand.
Remove the rubber buckle
⑴
at the right guard bar.Locate the plug for the oxgen sensor in the upper right guard
bar,press the indicated by arrow "a" with one hand and pull the plug in the direction of arrow "b" with the other
hand.
●
Muffer rear assembly
Remove the bolt
⑷
wiht 6# inner hexagon socket and remove clamp
⑸
.
After support the muffer rear assembly then remove the bolt
⑹
wiht 6# inner hexagon socket,take off the
bushing
⑺
,remover the muffer rear assembly from the vehicle.
Take off the graphite gasket
⑻
,protect the nozzle,if it's deformed,it may cause leakage.The graphite gasket may
be left in teh rear assembly or in the front assembly when removed.
CAUTION:
●
The parts should be protected during disassembly to prevent damage to the paint.
●
The muffler should be completely cooled before it is disassembled.
●
Prevent foreign matter from entering the interior of the muffler.
●
The muffler nozzle needs to be protected. If there is any deformation, it may cause air leakage.
●
It is recommended that new seals be replaced each time the muffler front assembly is removed to prevent
airleakage.
