12-CUSHION COMPONENT
88
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
ZT350
－
GK cushion component
1
2
1244100-024000 ZT250
－
S cushion front rubber
2
3
1244300-033000 ZT350 cushion rubber
2
4
1244100-025000 ZT250
－
S round cushion rubber
6
Fig.1 CUSHION
COMPONENT
Cushion component
After-sale
PROCEDURE:
●
Remove seat cushion
Press the unlock button " " shortly.After the power-on self test is completed, press the "SEAT" button briefly
to open the electronic cushion lock.
Grasp the seat cushion
⑴
and pull it diagonally upwards. At the same time, remove the cushion by moving the
rear part of the cushion from side to side.
●
Cushion rubber
The corresponding installation position is shown in Figure2.
●
Assembly cushion
Grasp the front turning point and tail of the cushion as shown in Figure 3, and align the head of the cushion
with the edge of the middle cover of the oil tank, as shown in Figure 4.
Press and hold the turning point at the front of the cushion with your left hand to make the two inner sides of
the cushion flush with the side cover to prevent the cushion from being biased to one side to scratch the cushion,
as shown in Figure 5.
Press the turning point with your left hand and push forward with your right hand against the tail of the
cushion, as shown in Figure 6.
Insert the buckle of the cushion head into the bracket on the oil tank, as shown in Figure 7.
After checking that both sides and head of the cushion are assembled in place, press the tail of the cushion by
hand and lock the cushion, as shown in Figure 8.
CAUTION:
●
The motorcycle should be fixed before operation.
●
Cushion can cause accidents if it is not installed properly.
