6-COOLING SYSTEM COMPONENT
35
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
2
4050454-014051 ZT180MN fine filter cover A (dark gray)
1
3
1051454-020000 55×2.5 Hydrogenated nitrile rubber O-ring
1
4
1051454-005000 ZT180MN Oil filter sealing ring
1
5
4134300-001000
ZT184MP fine filter sealing assembly(carton packaging)
1
【
2
】
6
1050853-009000 Φ16.4×17×1.6 filter spring
1
Fig.2 COOLING SYSTEM
COMPONENT
Change engine oil filter
PROCEDURE:
●
Change engine oil filter
Place holder to collect wasted engine oil under right crankcase cover.
Using 10# sleeve disassemble nut
⑴
. Rotate slightly engine oil refined filter cover
⑵
and take it off when it is
loosen.
Remove O-ring
⑶
and sealing ring
⑷
;Change engine oil filter
⑸
.
Check if seal ring
⑶
is broken. Change the seal ring
⑷
along with engine oil filter is suggested.
When reassembling, pleas check carefully if the spring
⑹
, seal ring
⑷
are well installed. Engine oil filter can
not be turned over when assembling.(as shown in the left figure,
①
face the fine filter cover;
②
face the engine)
When assembling,first assemble the fine filter cover
⑵
and O-ring
⑶
,and then cover it on the fine filter.
CAUTION:
●
Ensure every component is well assembled.
●
It is recommended to replace the O-ring
⑶
when replacing the filter element. Check whether the sealing ring
⑷
is damaged. If not, clean it and replace it; If damaged, it must be replaced.
●
Engine oil filter can not be turned over when assembling.
●
Note that the seal ring
⑹
is facing the fine filter with the “OUT SIDE (TOWARDS FILTER COVER)” side.
It is forbidden to install reverse or leak.
●【
1
】
Due to status change,if this nut needs to be replaced,3 pieces shall be replaced at the same time.
●【
2
】
The ZT184 refined filter seal component already included oil filter/55×2.5 O-ring
⑸
and ZT184MN
Engine oil refined filter seal ring
⑹
.
1
1251300-056093 M6 cover type 9 degree nut (environmental color zinc)
3
【
1
】
After-sale
