4/10/2019
V4 User Manual and Installation Guide – Zonar Systems Support
https://support.zonarsystems.net/hc/en-us/articles/360017847851-V4-User-Manual-and-Installation-Guide
11/27
Use on light duty vehicles equipped with OBDII Diagnostic Port™.
Requirements:
1. OBDII Diagnostic Port
2. Sticker or plate under the hood explicitly stating "OBDII
Compliant" or "OBDII Certified". See example to right.
3. Do not use on hybrid vehicles.
4.
The Light Duty cable cannot be installed on vehicles that
already have third party a ermarket equipment installed on the
OBDII network
(e.g. wheelchair li transmission lockout, boom
truck transmission lockout, fuel monitoring devices, etc.)
OBDII_sticker.png
Failure to comply with these requirements may cause interference with the safe and normal
operation of the vehicle.
Installation:
1. Connect to OBDII diagnostic port with engine running.
Failure to perform this step may trigger a false Check Engine
light on the dash on first engine start a er installation.
This will require the fault to be manually cleared.
2.
Required.
Drive vehicle for a minimum of 100 feet at 5 MPH or more to properly complete new install checkout. If
this is not performed GPS and discrete IO data will not be present in Ground Tra ic Control™ until those thresholds
are met.
9 Pin Diagnostic Cable (part# 81523)
Use this cable on heavy duty vehicles with SAE J1939 databuses. The cable connects to the 9 Pin Deutsch diagnostic
port, typically found beneath the driver-side dashboard.
