4/10/2019
V4 User Manual and Installation Guide – Zonar Systems Support
https://support.zonarsystems.net/hc/en-us/articles/360017847851-V4-User-Manual-and-Installation-Guide
10/27
6. 10 Pin ECM input (SAE J1708/J1939 & OBDII equipped vehicles)
Power And Data Connections
Connecting to Vehicle Electrical and Data System
Do not connect to the 4 pin power input until all other V4 cables have been connected.
There are four primary methods to connect the V4 to your vehicle’s electrical and data system:
1. 4 Pin, 3 Wire Power Cable (part# 10007)
2. Light Duty Power Cable (part# 81153)
3. 9 Pin Diagnostic Cable (part# 81523) with optional 6 Pin adapter (part# 81632)
4. 2 Pin Deutsch Backbone Cable (part# 81517)
Additionally there is a fi h uncommon cable specifically used to wire around battery disconnect systems:
5. 4 Pin, 4 Wire Power Cable (part# 10030)
See General Guidelines before you begin. Do not connect to the 4 pin power input until all other V4 cables have been
connected.
4 Pin, 3 Wire, Power Cable (Part# 10007)
Use this cable for equipment
NOT
equipped with any of the following databuses:
OBDII (light duty/commuter vehicles)
JBus 1708/1587 (heavy duty vehicles 2010 and earlier)
JBus 1939 (heavy duty vehicles 2006 and later)
See wiring procedures below.
NOTE:
Requires vehicle to physically move at least 5 MPH for at least 100 feet to properly complete new install
checkout. If this is not performed GPS and discrete IO data will not be present in GTC until those thresholds are met.
Light Duty Cable Kit (part# 81153)
This kit consists of two parts:
Light Duty, Power/Data Cable (part# 81008)
Light Duty Breakout (part# 80999)
