17
FR
EN
PL
NL
ES
PT
How to change the length of the contact points
The anti runaway fence comes equipped with standard 5/8” contact points that can be extended to
3/4” contact points, for use with dogs with longer coats.
To increase the contact point length from 5/8” to 3/4”, follow the steps below.
1. Using the included adjustment tool with the side marked «5/8», unscrew the contact points
counter-clockwise.
2. Place the contact point extension over the exposed threads, flat side down.
3. Place the contact points over the extensions and tighten the contact points and extensions
clockwise using the adjustment tool with the side marked «3/4».
* Caution: Tighten until firmly in place. Be careful not to over tighten.
To shorten the contact points back to the standard 5/8”, start with the adjustment tool with the side
marked «3/4», remove the contact point extensions, and tighten the contact points with the
adjustment tool with the side marked «5/8».
TESTING YOUR ANTI RUNAWAY FENCE ZOLUX PRIOR INSTALLATION
1. To ensure that your anti runaway fence system is working
properly, connect the power adaptor into the transmitter
power jack and then plug the power adaptor into a household
outlet. Switch the stimulation knob to Pager + Stimulation, or
Pager Only. The On/Off indicator light should turn on.
2. Unwind the length of ground wire that was provided and
strip about 1/2 inch off each end. Insert both ends of the
ground wire into the outer, red wire connector jacks, leaving
the center jack free. If the wires are connected properly, the
wire indicator light will be on.
3. Next, activate the receiver/collar by turning the intensity
level dial on the receiver to the desired level. The LED light will
blink once every two seconds showing that it is on.
* If not activated for 10 seconds or more, the system will go into sleep mode.
4. Hold the receiver in your hand with the contact points facing up. Place the test lamp over the
contact points and approach the test loop.
5. Watch for the test lamp to come on and the unit to vibrate. Be careful not to touch the contact
points as the unit will emit stimulation when activated.
