FR
EN
PL
NL
ES
PT
16
Proper fit
The collar should be fitted so that the surgical stainless steel contact points press firmly against the
dog’s skin. You should be able to fit a finger in between the
contact point and your dog’s skin. The best location is either
side of the dog’s windpipe. A loose fit can allow the collar to
move around on the dog’s neck. When this happens, the
contact points may rub the skin and cause irritation. If the
collar is too loose, electrical contact will be inconsistent
and your corrections will be inconsistent also.
Attention!
Leaving the receiver/collar in the same location on the dog’s neck, for an extended period of
time can cause skin irritation. If the dog is to wear the e-collar for long periods, occasionally
reposition the collar so that the contact points are moved to a different location on the dog’s
neck. Make sure you check for skin irritation, each time you use the unit.
Receiver/Collar Battery Charging Receptacle
On the inside of the receiver/collar, next to the collar strap, is a battery
charging receptacle with a rubber plug.
The unit will be fully waterproof with or without the rubber plug. If the dog
was in salt-water, be sure to rinse the receiver and charging port with clean
water, and let air dry.
Adaptor
The battery charger is designed
for a 220-volt wall outlet.
Charging the Receiver/Collar
Zolux uses Lithium-Polymer batteries.
1. Charge the unit before using the unit for the first time.
2. Do not charge the batteries near any flammable substances.
3. Fully charge the batteries if the unit is to be stored without use for a
period of 3 months or more.
Recharge the unit if:
1. The LED indicator light on the receiver/collar is emitting a red color.
2. The indicator light on the receiver will not come on.
3. The indicator light on the receiver comes on momentarily, but will not stay on near the wire.
Battery Charging Procedure
1. Attach the charging cables to the receiver as shown.
2. Plug the charger into a 220-volt wall outlet.
When properly plugged in, all indicator lights should glow red.
During the charging process, the unit will shut off. Once the battery cable is unplugged from the
unit after a full charge, you will need to turn the unit on again before use.
3. The Lithium-Polymer battery is fully charged within 2 hours.
The lights will stay red during the charging process.
The red light will change into a steady green light when the battery is fully charged. (When you
disconnect the charger after finishing the charge, you will need to restart the units).
4. After charging, cover the battery charging receptacle with the rubber plug on the receiver/collar.
Note: Only use Zolux-approved batteries, chargers, and accessories for the anti runaway fence.
Unauthorized chargers may cause the unit to malfunction and the indicator light to blink in an
amber color.
(24Volt 500mA)
Tranmistter
Adaptor
Receiver Adaptator
(5Volt 1A)
