3
General Information
Warnings and Cautions
:DUQLQJV
*HQHUDO
•
The Base PowerCharger
1x1
has been tested against
interference from radio frequency emissions typical
of two-way radios used in emergency service/public
safety activities. Users of the Base
PowerCharger
1x1
should refer to Section 5 to
determine recommended operation distances from
RF transmission equip
ment.
•
Use only the AC power line cord supplied with the
device. Failure to use the proper line cord could
result in excess leakage currents and reduced
safety.
•
Do not disassemble the Base PowerCharger
1x1
. A
shock hazard exists. Refer all problems to ZOLL
Technical Service.
•
Follow all recommended maintenance instructions.
If a problem occurs, obtain service immediately. Do
not use the Base PowerCharger
1x1
until the unit has
been inspected by the appropriate personnel.
•
Do not place anything on top of or beneath the Base
PowerCharger
1x1
, such as blankets or cloths. Doing
so may block the vents on the unit, preventing
proper dissipation of heat during operation.
•
Do not use adjacent to or stacked with other
equipment. If adjacent or stacked use is necessary
the Base PowerCharger
1x1
should be observed to
verify normal operation.
•
Do not sterilize the Base PowerCharger
1x1
.
•
Do not use alcohol or ketones (MEK, acetone, etc.)
on the Base PowerCharger
1x1
.
•
Always wait until the Base PowerCharger
1x1
has
completed its charge cycle before removing
batteries.
•
Repeated use of partially charged batteries will
reduce their capacity and operating life.
•
Do not use a battery unless the
BATT. READY
indicator is lit and the
FAULT
light is off. Failure to do
so may result in the use of a fully depleted battery.
•
Do not install batteries into Monitor/Defibrillators
when storage may exceed 90 days. Battery damage
may occur.
2SHUDWRU6DIHW\
•
Do not operate the Base PowerCharger
1x1
in the
presence of flammable agents (such as gasoline),
oxygen-rich atmospheres, nitrous oxide, or
flammable anesthetics. Using the device near the
site of a gasoline spill may cause an explosion.
•
Do not immerse or set the Base
3RZHU&KDUJHU
[
in
liquid. Using the device near or within puddles of
water may present a shock hazard to the operator,
patient, and nearby personnel.
3DWLHQW6DIHW\
•
Do not mount the device directly above the patient.
Locate the Base
3RZHU&KDUJHU
[
and ZOLL
resuscitation devices where they cannot harm the
patient if they fall.
&DXWLRQ
•
When a fully charged battery is placed into the Base
PowerCharger
1x1
with the AutoTest, the AutoTest
will
NOT
activate and the
BATT. READY
indicator
will illuminate within a few minutes after inserting the
battery into the charger. Since the AutoTest
sequence is not performed, it is possible to have a
shorter battery run time than expected.
Summary of Contents for Base PowerCharger 1x1
