ZOLL Base PowerCharger 1x1, Operator'S Manual

Page: 13 / 26

9
Operation
2.
Insert battery into the compartment. Make sure the
battery is fully seated (A click can be heard).
3. The CHARGER ON and TESTING indicators illuminate
and remain on during complete AutoTest and recharge
cycle (shown). Only the
CHARGER ON indicator
illuminates during a QuickCharge recharge cycle.
4. In 8 hours or less for the PD 4410/Smart Battery or 15
hours or less for the XL Smart Battery (using AutoTest)
the
CHARGER ON light will go off and the BATT.
READY light will illuminate indicating the battery has
passed the capacity test and is fully charged and ready
for use.
In 4 hours or less for the PD 4410/Smart Battery or 8
hours or less for the XL Smart Battery (using
QuickCharge) the
CHARGER ON light will go off and the
BATT. READY light will illuminate indicating the battery
has been charged to 100% of its present capacity and is
ready for use.
If the battery or charger is not capable of charging, the
FAULT light will illuminate and the CHARGER ON light
may stay on. Before discarding the battery, test the
battery compartment for defective operation (see
Operational Checks Section) and perform a second
battery test.
5. To remove the battery, insert a finger into the recess at
the top of the battery compartment, press against the
battery to disengage the battery locking clip and lift the
battery out. A charger test is performed illuminating all
LED's briefly followed by the
BATT. READY and
TESTING indicators illuminating for 2 seconds and then
all LED's go off except for the POWER LED.
0DQXDO%DWWHU\7HVWLQJ3URFHGXUH
Although this test is available, the Auto Test feature
eliminates the need to manually test batteries since battery
capacity is automatically tested with each battery recharge
(except when a fully charged battery is placed in the unit).
It is not necessary to insert a fully charged battery for
testing; the Base PowerCharger
1x1
will automatically test the
battery regardless of charge status.
To test a battery:
1.
Check to see that the Base PowerCharger
1x1
is con-
nected to live AC mains. The POWER light should be
lit.
2.
,QVHUWEDWWHU\LQWRWKHFKDUJHU0DNHVXUHWKHEDWWHU\
LVIXOO\VHDWHG
(A click can be heard).
3. Press the TEST button. The TESTING indicator light will
illuminate for the duration of the test cycle.
4. If the battery passes the test, the BATT. READY light will
illuminate while the TESTING light remains lit indicating
the battery is fully charged and ready to use. See the M
Series Operator's Manual for run time information.
5. If a battery fails the test, the FAULT light will illuminate
while the TESTING light remains lit. Before discarding
the battery, test the battery compartment for possible
defective operation (See
Operational Checks Section).
Repeat Battery test.
6. Record the date and results of the test on the battery
label.