![background image](http://html.mh-extra.com/html/zoje/wr580/wr580_product-manual_936864037.webp)
Error solution
Steps:
1.
Check whether the inlet voltage of control box is stable, if it’s within the
specified range
of
200V-250V
2.
when standby, enter monitoring interface of operation control box and see what’s the voltage appear
in UDC interface, then run the motor to see how much voltage rise while scram(usually around 410V
)[the inlet voltage multiplied by 1.41 = interface voltage]
3.
if the voltage showed in UDC is wrong, using Isolation transformer with 80V to supply power, then
detect the both ends voltage of + /- control board’s rectifier bridge: inlet voltage multiplied by 1.41;
C73 ends impedance: around12.5K; Two terminal voltage (means pin3 to pin4 safety line of U9):
around 0.56V
4.
if the voltage showed in UDC is wrong, using Isolation transformer with 80V to supply power, then
see impedance of R143 of main control board: 100
Ω
; C77 Two terminal impedance: around 3.3M;
Two terminal voltage (means pin1 to pin4 safety line of U9): around 0.56V.
5.
[share the maintenance picture with E3]
E5
---Overvoltage when running (the bus voltage is greater than 460v
for 10ms when running)
Summary of Contents for WR580
