8
© Copyright 2017 Zoeller
®
Co. All rights reserved.
Typical Outdoor Grinder Pumping System Installation
All installations must comply with all applicable electrical and plumbing codes, including but not limited
to the National Electrical Code, local, regional and/or state plumbing codes, etc.
FIGURE 3.
R
LOUISVILLE, KY
SILENCE
INPUT 1
POWER
4" PIPE SEAL
(FIELD INSTALLED)
2" PIPE SEAL
(FIELD INSTALLED)
24" MIN.
FIBERGLASS AFD
1.25-2" Z-RAIL
2" CAST IRON CHECK VALVE
3/4" GALV. GUIDE RAILS
2" SCH. 80 BALL VALVE
2" FLEX BOOT FITTING
(LOCATION VARIES
WITH BASIN DEPTH)
FLOAT TREE ASSEMBLY
2HP GRINDER PUMP
2" PVC SCH. 80 PLBG.
1/8" 302 STAINLESS STEEL
LIFTING CABLE
ALARM
ON
OFF
SOLID FIBERGLASS COVER
HIGH WATER ALARM
OR SIMPLEX
CONTROL PANEL
(FIELD INSTALLED)
ALARM FLOAT SWITCH MUST OPERATE OFF
LOW VOLTAGE TO BE USED WITH QWIK BOX.
SK3110
FOAM TAPE
UL LISTED
EPOXY SEALER
#10-2350 POTTING KIT
APPLIES TO INSIDE AND
OUTSIDE INSTALLATIONS
CONDUIT
1
WIRES OR
PUMP CABLES
1/4" TO 1/2"
(25 mm)
(6.4 mm TO 12.7 mm)
SK1661
LOCATION VARIES WITH BASIN DEPTH
