10
2. Standing near the Fit, use your phone, tablet, or computer to look for the Fit’s SSID in your WiFi settings (see Figure B). It will look like
“ZCTL_Fit_xxxx” where “xxxx” is the first 4 digits of your Fit’s Device ID. Select this, and 2 things will happen:
1. The Z Control
®
LED will.
2. A Z Control
®
setup screen will open after a few seconds.
If the setup screen does not appear, open a browser on the same device and type “192.168.125.1” in the address bar. If the setup screen
appears but is not used (cancelled or otherwise closed), the Fit will return to AP mode and the Z Control
®
LED will turn off until the next
WiFi setup attempt.
3. On the setup screen (see Figure C), press the “WiFi Scan” button, scroll down to see the list of WiFi signals found, and choose the WiFi
you want the Fit to use for internet connectivity. Enter the password for the router you chose in the field indicated. If the password is
correct, the Fit will connect to the router and start sending status updates to zcontrolcloud.com. You will see the Z Control
®
LED go from
blinking to solid. This could take up to a minute or so.
The Fit is capable of OTA, or “over the air” firmware updates. It’s possible that the Fit could perform an update immediately if one
is available at the Z Control
®
Cloud. If an update is taking place, the Z Control
®
LED will flicker for up to 1 minute while the update is
downloaded. The Z Control
®
LED will be solid and all other LEDs will turn off while the update is being installed. After up to 1 minute,
the Fit will restart and return to normal operation. The Fit’s alert history on the Z Control
®
Cloud will also be updated with the firmware
upgrade information, and nofication to email accounts will occur.
If the LED does not turn solid, then the password entered is incorrect, the router’s security is insufficient (see note below**), or some
other network restriction is in place (see your network administrator). The Fit will return to standby mode if the connection to router is
not successful. If you need to force the Fit into AP mode again, press the Z Control
®
button for 12 seconds. This will cause the Fit to re-
enter AP mode and begin transmitting its SSID again.
Select the Fit’s SSID
Click WiFi Scan button
Available WiFi will be listed here.
Select the one you want.
**Note that the Fit will not connect to routers with “WEP” or “OPEN” security.
Figure B
Figure C
Fit
© Copyright 2019 Zoeller
®
Co. All rights reserved.
