EN
H0426500.B EN - 2015/02
8
5. Maintenance
To avoid any electric shock and any other risks that may cause serious injury or death, disconnect the cleaner
from the power supply before you carry out any cleaning or maintenance.
5.1. Cleaning the filter
The cleaner performance can be reduced if the filter is full or dirty. At the end of each cycle, clean the filter in
fresh water for effective cleaning.
Filter access
• The lid's handle rises automatically when you press the Push’n’Go™ button
(1;2).
• Remove the "lid + handle" assembly using this handle
(3).
• Press the two locks on the lid to release the filter
(4;5).
• Clean the filter in fresh water
(6).
4
5
6
1
3
2
"Clean filter" indicator (RC 4400)
If the "clean filter" indicator on the control box lights up, it is strongly recommended to clean the filter.
If the indicator comes on during a cleaning cycle, it will remain on until the end of the cycle.
5.2 Replacing the brushes
• The cleaner is fitted with PVC brushes. They have wear indicators
(1).
• To remove worn brushes, remove the tabs from the holes in which they are fixed.
• To fit new brushes start by fitting the side without tabs under the brush holder
(2).
• Roll the brush around its support and slide the tabs into the fixing holes
(3).
• Using non-cutting pliers, pull the end of each tab to slide it through the slot
• Cut the tabs using a pair of scissors for them to be level with the other blades
(4).
1
2
3
4
We recommend that you change the brushes after 2 seasons' use.
