EN
H0426500.B EN - 2015/02
6
3. Description of the control boxes
Box control
symbols
Symbol description
RC 4100 - RC 4300 - RC 4350
RC 4360 - RC 4370 - OC 3300 - OC 3400
RC 4400
Starting / Stopping the cleaner
"Control" indicator
Surface to be cleaned*
Bottom only (1h30)
sides + water line
(2h30)
Surface control*
"Clean filter" indication
Cleaning time adjustment*
Increase by 30 minutes
Reduce by 30 minutes
=> *The LEDs light up to show which mode is selected.
4. Use
4.1 Starting up the cleaner
ͳ
Do not touch the cleaner when it is operating.
ͳ
To prevent any damage to the cleaner, always remove the cleaner from the pool before you add any chlo
-
rine or acid.
ͳ The pool cleaner is so efficient that it is not necessary to run more than 3 cycles per week
ͳ The first time you use the cleaner, we recommend that you launch a "bottom only" cleaning cycle.
ͳ The cleaning cycle can be customised at any time, before the cleaner starts or while it is operating.
• Before each cleaning cycle, roll the floating cable out along the pool.
• Connect the control box.
• The following lights come on the first time you connect:
bottom and walls
(factory setting).
• Press the
button to select the
"bottom only"
cycle or the
" walls + water line"
cycle.
• You may launch a cleaning cycle by pressing the
button; the cleaner remains immobile for a few seconds while
the system configures, then starts up.
• It is normal for your cleaner to stop for a few seconds sometimes: it is calculating and adjusting its trajectory for opti-
mum cleaning of the whole surface of your pool.
4.2 Adjusting the cleaning time (RC 4400)
You may reduce or increase the cleaning time at any time (+/- 0.5 H).
normal
duration
-
0.5
H
+
0.5
H
• Press the button:
