H0426500.B EN - 2015/02
3
1.3 Technical specifications
Control box power supply voltage
220-240 VAC, 50 Hz
Cleaner power supply voltage
30 VDC
Max absorbed power
150 W
Cable length
15 m / 18 m (RC 4400)
Cleaner size (L x W x h)
41 x 42 x 28 cm
Package size (L x W x h)
56 x 56 x 46 cm (RC 4100 - RC 4350 - RC 4360 - RC 4370 - RC 4400 - OC 3400)
56 x 56 x 38 cm
(RC 4300-OC 3300)
Cleaner weight
9 kg
Packaged weight
18.4 kg (RC 4100 - RC 4350 - RC 4360 - RC 4370 - RC 4400 - OC 3400)
14.3 kg
(RC 4300 - OC 3300)
Theoretical cleaning width
220 mm
Pump flow
16 m³/h
Cycle duration
Bottom only (1h30) / walls + water line (2h30)
1.4 Recommendations for use
• When the pool is dirty, especially when commissioning, remove the largest debris using a net in order to optimise
cleaner performance.
• Remove any thermometers, toys and other objects that might damage the cleaner.
• The cleaner must operate in pool water with the following characteristics: chlorine < 3 mg / l; pH between 6.8 and 7.6;
temperature between 15°C and 35°C.
• Immerse the cleaner before launching a cleaning cycle.
• Start by launching several bottom-only mode cleaning cycles.
• Never cover the control box while the cleaner is in operation.
• You can operate the filtering pump during a cleaning cycle; the particles placed in suspension by the cleaner will thus be
filtered out. However, if you see that the behaviour of the cleaner is influenced by the jet as the discharge nozzle level
when the filtering pump is operational, we advise you to start your cleaner when the filtering pump is not operating.
• If part of the pool is not properly cleaned change the place where you immerse the cleaner until you find the best spot.
• Regular use of the cleaner means that your pool will always be clean and the filter less clogged.
1.5 Immersing the cleaner
Bathing is prohibited when your cleaner is in the pool.
• Roll out the full length of the cable alongside the pool
(1)
to avoid the cable becoming entangled when the cleaner is
immersed
(4).
• Place the cleaner vertically into the water
(2).
• Move it slightly in all directions so that the air contained in the cleaner escapes
(3).
• It is essential that the cleaner sinks on its own and settles on the pool bottom. While it is immersed, the cleaner draws
the length of cable it needs into the pool.
1
1
2
3
4
1
For better operation, place the control box in the centre of the pool's length, following the safety conditions
relating to electrical connection (see § 1.6).
