![background image](http://html1.mh-extra.com/html/zodiac/jxi200n/jxi200n_workbook_3994414010.webp)
Vent Connection
and Pipe Sizing
Figure
3
Figure 4
V
ent Pipe or Elbow Increaser Installation
(Category I and Category III)
1.
Remove the exhaust body.
2.
Remove the exhaust rain shield .(Figure 1)
Exhaust Vent
Rain Shield
3.
Category I:
Install a draft hood connector and an increaser to
meet the vent size requirements per Table 2. (See
Figure 2.)
Category III:
Install vent connector or elbow to the flue colla
according to the specific i stallation instructions
from the vent connector or elbow component
manufacturer.
Figure 2. R
emove Exhaust Body and Rain Shield
Figure 1
Figure 2
Figure
2.
Remove Exhaust Body and Rain Shield
4.
Wipe the socket of the vent body with rubbing
alcohol using a clean cloth or paper towel, then.
dry with a different clean cloth.
5.
Connect the vent connector to the lue collar and
fasten with three (3) sheet metal screws, as
shown in Figure (3).
Figure
3
. Correct positioning of screws
on vent collar
6.
Apply high temperature silicone RTV at the
connection to seal, as shown in Figure 4.
NOTE:
Use a minimum 600
°
F (315
°
C) temperature rated RTV.
Figure
4
. Seal Connection with RTV
10
Summary of Contents for JXI200N
Page 1: ...1 Workbook JXi Pool Spa Heater...
Page 2: ...2...
Page 23: ...Exhaust Temperature Switch R0524300 Burner R0591700 23...
Page 26: ......