![background image](http://html1.mh-extra.com/html/zodiac/exo-10/exo-10_instructions-for-installation-and-use-manual_936564026.webp)
24
3.4 I Installing the sensors on the POD kit
•
Screw the one or more threaded sensor holders onto the POD kit,
see fi gure
.
•
Carefully unscrew the protecti on tube from the sensor,
see fi gure
. Keep the protecti on tube for storing
the sensor over winter.
•
Rinse the end of the sensor with tap water and shake off excess water,
see fi gure
.
• Never wipe the sensor using a cloth or paper ti ssue, as this may damage it.
• A badly-installed sensor may give false readings and cause inappropriate operati on of the
appliance. Neither the manufacturer nor the appliance shall be liable in this event.
•
Screw the sensor into the sensor holder by holding the BLUE or YELLOW ti p in one hand and the black ti p
in the other hand to prevent the cable from tangling,
see fi gure
.
•
Once the sensor has been installed on the POD kit, it can be connected to the BNC socket (BLUE = pH;
YELLOW = ORP) of the pH Link or Dual Link module,
see “2.5.3 Electrical connecti on steps”, see fi gure
.
•
The sensor must then be calibrated,
see
“5.3 I Calibrati ng the sensors (if an opti onal “pH Link” or “Dual
Link” module has been installed)”