97197
December 19, 2003
9
Oval Pool
-
Escapade
IMPORTANT NOTE: Fasten
all hardware securely.
B. Lay spacer plates between side supports with the lip
side down (Fig. 8B). Do not attach at this time. Spacer
plates will overlap on the 15' x 30' and 18' x 33' pools. For
the 8’ x 12’, 10’ x 15’, and 12’ x 18' pools, lay out as shown
in Figure 7.
C. Secure the tie bar joiner and spacer plate to each
Omega using 1 ea. #14 x 5/8" self-tapping screw and 2
ea. 5/16-18 3/4" truss head machine screw and 5/16-18
USE WITH
1524, 1530
USE WITH
1833
TO SPACER
PLATE
TO SPACER
PLATE
TO SPACER
PLATE
One end of every tie bar joiner has 4 holes. See pictures below for
correct hole usage (See previous page for the 8’ x 12’, 10’ x 15’, and
12' X 18' pools).
IMPORTANT: F. Fill in and tamp down any open
area around the inside of the Omegas including
the spacer plates. If this is not done properly it may
cause craters (space gaps) in your liner.
1833 CONFIGURATION
POOL
SIZE
NO. OF
STRAPS
8' x 12'
1
10' x 15'
1
12' x 18'
2
15' x 24'
4
15' x 30'
8
18' x 33'
12
NOTE: Some 15’ tie bar joiner only have 4 holes, use the outside holes for assembly if you
have these tie bar joiners.
TO SPACER
PLATE
1524, 1530 CONFIGURATION
1218 CONFIGURATION
hex nuts (Fig. 8B). Refer to the tie bar joiner assembly
diagrams shown above. At this time do not connect
the tie bar joiners. Complete one side before begin-
ning the other in the center of the pool.
D. Insert the small piece of styrofoam you cut off
earlier and insert it into the Omega making sure that
the end of the styrofoam is flush with the inside end of
the Omega.
E. Remove 2" x 4" supports and secure the tie bar
joiner assemblies using 5/16-18 3/4" truss head
machine screw and 5/16-18 hex nuts (Fig. 8C).
A. RIM CONNECTOR INSTALLATION:
Rim connector will bend to conform to the shape of the pool.
Insert rim connector into short (41") rim.
Rims and rim connector should be assembled as shown
here.
.
Place assembly in the center of the upright.
1
2
3
