DIRECTIONS - FOLLOW THESE DIRECTIONS AT ALL TIMES
Read, understand and follow the instructions printed in this instruction manual, on shower and on propane cylinder before operating this product.
Failure to comply with all instructions can result in serious bodily injury, death and/or property loss. CARBON MONOXIDE HAZARD - Operating
this item in an enclosed space can kill you. Never use this appliance indoors or in an enclosed space such as a camper, tent, car, boat or home. Zodi
assumes no responsibility for improper use. These directions may refer to options not included on your model. Keep children & pets away from
product when operating. Water must always be flowing from showerhead when igniting and whenever heater is on.
This package contains:
• hot camp shower
• pump with twist off debris cap
• battery case (4 D-cells needed)
• multi-purpose storage case
• instruction manual
• warranty card
STEP 2
Completely attach pump to free end of
shorter hose. Place 4 D-cell batteries (not
included) in the battery case. Sticker inside
battery case shows correct position of
batteries. Use new alkaline batteries for best
performance.
STEP 3
Close lid and snap clasp shut to secure lid in
locked position.
TIP: Bend out battery contacts in case lid and
case bottom to ensure good battery connection.
Also see back of battery case for more tips.
Do not mix old & new batteries. Do not mix
alkaline, carbon-zinc, or rechargeable batteries.
STEP 4
Test your pump by pressing red button
on battery case lid. You should hear your
pump spinning. If pump fails check that
batteries are installed correctly or replace
with new batteries.
STEP 5
Turn off propane gas valves and then twist
2 standard 16.4 oz disposable propane
cylinders clockwise into gas valves at
bottom of heater. Check that gas cylinders are
tight and not leaking at connections. Test for
leaks (see page 3).
STEP 7
Place pump in plastic storage case or
other container of water. Shake pump
under water to release trapped air. Push
red button on battery case to start water
flow. Water should now be flowing from
showerhead.
NOTICE
Do NOT proceed to Step 8 without
water flowing from showerhead.
WATER MUST ALWAYS BE FLOWING
FROM SHOWERHEAD WHEN
HEATER IS ON.
STEP 8
Open gas valve closest to ignition button
& quickly push piezo ignition button 2 to 4
times. Check for ignition by feeling for heat
rising from top of heater. If system fails to
ignite within 2 seconds, turn off gas valve &
wait 1 minute.
STEP 9
If piezo button gets wet, it may short out until
it dries. Insert match or lighter flame into hole
on right side of heater & slowly open gas
valve nearest to flame. Once first burner is
ignited, turn second valve on to ignite second
burner. Check for heat rising from top of
heater.
STEP 10
System is now heating water. If water
flow/pressure drops, water temperature
suddenly increases or hoses come off of
shower or pump, point showerhead away
from body & safely turn off heater until
proper water pressure is regained.
STEP 1
Select flat area 15ft (5M) away from tents,
vehicles & flammable material. Attach hoses
to their corresponding hose fittings (as labeled
on unit) by twisting and applying pressure until
hoses fit completely over the barbed fittings. If
not snug, trim end of hose.
STEP 6
Remove plastic lid from case & position
lid on flat ground. Insert propane
cylinders securely into plastic lid cavities.
Uncoil hoses and remove any kinks from
hoses. Fill open storage case with water.
DO NOT OPERATE INDOORS. FOR OUTDOOR USE ONLY.
Propane products emit carbon monoxide which can kill you. Never use in enclosed space.
CAUTION
