p.
55/61
Photosensor
malfunctioning
Check the condition and
functionality of the photosensor
Check the position of the heat
capacity potentiometer
The operating
parameters of the
control board have
been changed
Check the operating parameters of
the burner’s control board –
it
should be performed by authorized
technician only;
11.
The operation of
the burner is not
stable
The position of air
flow control flap
has been changed
Adjust the position of the air flow
control flap by positioning it
according to the position of the
thermal capacity potentiometer and
corresponding their positions
according to the color scales
12.
Heating-up of
the pellet
delivery pipe
Insufficient
draught or ash
deposition of the
appliance
It is necessary to clean the ash
deposition of the appliance,
eventually clean the ash in the
chimney. A possible solution is to
install an additional flue gas fan
and/or change of the chimney *
13.
Heating-up of
the pellet
delivery pipe
and activation of
the pipe’s alarm
thermostat
Low draught or
high ash deposition
of the appliance
It is necessary to make thorough
cleanup of the ash, deposited on the
appliance, eventually the chimney.
It is necessary to restart the burner.
A possible problem solution is to
install an additional flue gas fan
serially to the heating appliance
and/or change of the chimney *
-
performed by authorized technician;
14.
Increased
temperature,
indicated by the
reversible liquid
crystal
thermosticker
Increased
resistance of the
flue gases duct or
insufficient
draught of the
chimney
It is necessary to make thorough
cleanup of the ash, eventually the
chimney. It is necessary to restart
the burner. A possible problem
solution is to install an additional
flue gas fan serially to the heating
appliance and/or change of the
chimney *
-
performed by
authorized technician;
15.
Activation of the
irreversible
thermosticker,
attached to the
fuel delivery
Excessive
operating
temperature levels
in the pellet
delivery pipe, in
It is necessary to make thorough
cleanup of the ash, deposited on the
appliance, eventually the chimney.
It is necessary to restart the burner.
Check the pellet burner and clean if
