Zline RBIV-30, Installation Manual

Page: 27 / 44

Forward-backward travel distance of the lower kick plate must be
5/16" (23 mm). As you can see in the figure, the decorative kick plate must not
be in front of the trim piece level.
Attaching the decorative parts
• Attach the side closing parts (1) onto the right/left connection brackets.t
• Attach the upper closing part (4) onto the upper connection bracket.
WARNING
DOOR PANEL PREPARATION
This section contains information about preparing the door panels and mounting
them to the product.
Attaching the door handles
• Handle mounting studs need to be installed prior to mounting the panel to
the product.
• The mounting stud needs to be on the decorative side of the panel, fix the
other side of the screw in place with a washer and nut.
Maximum weights of the door panels to be mounted to the product are
as follows.
Fridge Door: 35.7 lbs. (16.2 kg)
Freezer Door: 19.8 lbs. (9 kg)
Choosing the Door Thickness
• The door of your refrigerator can open by 115° maximum. If the door is
going to open to this degree, you can choose the following thickness levels.
WARNING
INSTALLATION
If the door thickness is more than 1 ½” (38 mm), the door should not open
more than 90°. You must use a limiting pin on the hinge.
• You can limit the opening degree of your door to 90° if you want. In
this case, the door thickness levels can be like the following (you can
look at the relevant section to learn how to attach the 90° limiting pin.
WARNING
INSTALLATION
48
Door P
anel Pr
epar
ation
47
Door P
anel Pr
epar
ation