Zline RBIV-30, Installation Manual

Page: 20 / 44

PREINSTALLATION
Continue to install the product according to the instructions below. Additionally,
consider national and local instructions regarding installation.
Please observe the following:
• For the USA, The National Electrical Code, ANSI/NFPA 70 – last version/State
or Municipality directives and/or regional directives.
• For Canada, The Canadian Electrical Code, C22.1 – last version/State or
Municipality directives and/or regional directives.
Mounting the Anti-Tip Brackets
Anti-Tip Brackets must be installed to prevent the appliance from tipping
over.
WARNING
Make sure that there is no electrical or water connection where the
screws will be tighten and connections will be established.
WARNING
Please remember to use the necessary protective equipment when
drilling holes on the wall and performing installation.
WARNING
• Mark the wall for Anti-Tip Brackets (7).
CATEGORY RBIV30 RBIV36
A 30" (762mm) 36" (914mm)
B 23 5/8" (600mm) 23 5/8" (600mm)
C 3 3/16" (81mm) 6 3/16" (157mm)
• Use a drill to create holes for anchors (8) at the marked points (5/16” -Ø8). Do
not use a larger drill bit as the wall anchors will be unable to tighten or secure
the brackets.
INSTALLATION INSTALLATION
33
Anti-Tip Br
ack
ets
34
Anti-Tip Br
ack
ets