Zirkon zahn ZIRKONOFEN 700, Operator And Maintenance Manual

Page: 12 / 44

12 12 CHAPTERL
SAFETY / RESIDUAL RISKS
PURPOSE
The intended use of the device is outlined in this chapter.
In this connection a hazard analysis was done on the Zirkonofen 700 & 700 Ultra-Vakuum
sintering furnaces. The manufacturer does not accept any responsibility for applications not
FGUETKDGFJGTGUKPEGVJG[FQPQVHCNNYKVJKPVJGFGſPKVKQPQHKPVGPFGFWUG
Intended use
All Zirkonofen 700 & 700 Ultra-Vakuum sintering furnaces must be used only for sintering the
pre-sintered zirconia produced by Zirkonzahn.
Improper use
No materials, tools and accessories from manufacturers other than Zirkonzahn must be employed
in the Zirkonofen 700 & 700 Ultra-Vakuum sintering furnaces.
Obligations of the user
The operator must make sure to:
- prevent touching of the device’s hot surfaces (burn risk),
- prevent that no other objects are placed on top of or beside the device (burn risk),
- prevent improper use,
- prevent other people staying within the working area of the equipment during operation,
- operate the system only with all intended safety devices closed and intact (front glass,
security switch, side covers etc.),
- use the personal safety equipment,
- disconnect the device from power supply by pulling the mains plug before any
intervention,
- operate the device only in a well lit environment of at least 500 lux,
- neither use water nor compressed air or solvents for cleaning,
- prevent maintenance work being carried out during operation.
Caution!
During operation, the device’s surfaces are hot and therefore must not be touched!
No objects must be placed on top of or beside the device!
Unplug from mains power when carrying out any connection and maintenance work!