MK-100377 Rev. A
19
Z I PP I E V O Y A GE
D. CUSHION ADJUSTMENT (ADVANCED)
The standard seat cushion comes in three seat lengths, short, medium, and long. The
short seat is 8" long, the medium seat is 10", and the long is 13”. Any excess cushion
for each range should extend under the back shell behind the seat. The cushions can
adjust 5.5 to 11.5 inches in width by adding or removing adductor foam pads.
Cushion types
1. Standard (A), ledge (B), and wedge (C)
2. Each type of cushion effects the child’s posture in a different and specific way.
3. Be sure to consult your health care advisor before changing the type of cushion.
To adjust the width
a. Unzip and remove seat cover. Add or remove the same combination of adductor
foam pads(D) from each side of the seat, to achieve the desired width.
b. Re-install the cover over the seat and pads, and close the zipper.
E. ADJUSTABLE CONTOUR CUSHION ADJUSTMENT (ADVANCED)
The contoured seat cushion comes in three seat lengths, short, medium, and long. The
short seat is 5" long, the medium seat is 7", and the long is 9”. These cushions can be
grown by an additional 3” by adding a 3" growth strip at the back of the cushion. The front
and rear section of the cushion (D) has Velcro® attachment points for positioning the
adductor wedges provided. They attach to the front and rear section of the cushion under
the foam overlay. The foam overlay attaches to Velcro® at the back of the seat.
Adding growth strips
a. Unzip seat cover and fold the top over the front edge to expose the cushion.
b. Lift the foam overlay piece away from the Velcro® attachment, using care not to tear
the foam.
c. Grasp the rear foam section at the middle and lift it from the velcro attachment.
d. Add either the 2" or the 3" growth strip at the back of the front foam section assur-
ing that the angled edges and sides align, and black foam is facing down.
e. Re-attach the rear section assuring the angled edges and sides align.
f.
Adjust the adductor wedges as needed and position the foam overlay over the cush-
ion and attach to the Velcro® at the rear of the seat.
g. Close the zipper around the cushion and install into the unit.
Cleaning the seat cover
a. Unzip the cover (E) along the edge.
b. Remove the cushion assembly from the Velcro® attachment inside the cover.
c. The fabric seat cover should be hand washed with laundry soap, thoroughly rinsed
with clean water, and air dried.
d. The foam cushion pieces may be wiped down with soap and water. Always be sure
they are completely dry before replacing the fabric cover.
e. Place the cushion into the fabric cover and onto the Velcro® with the front edge of
the cushion aligned with the front edge of the cover.
f.
Pull the cover over the cushion and close the zipper around the cover.
F. PLANAR CUSHION WITHOUT LATERAL SUPPORTS (ADVANCED)
Adding growth strips
The standard cushion without lateral hip supports comes in three seat lengths,
short, medium, and long. The short seat is 8" in length, the medium seat is 10",
and the Long is 13”.
32
3
3
3
4
35
3
5
3
4
IX. DEALER SERVICE & ADJUSTMENT
32
A
B
C
D
E
3
3
D
