15
Z I PP I E XP R E SS
J. TILT IN SPACE ANGLE ADJUSTMENT
WARNING
BEFORE using the tilt adjustment, always check that the mobility device is completely
unfolded and in the locked position, and that all four wheels are locked in place. Be careful
to avoid pulling or crimping any life support tubing that may be attached to the child.
Always remember to stabilize the mobility device before performing this action.
•
Rotate the front casters until they point forward.
•
Engage the wheel locks.
Tilt adjustment
a. Move to the rear of the device behind the child.
b. Support the seating shell with both hands and squeeze the tilt-in-space lever(A).
Position the shell to the desired tilt angle adjustment. The back support, and seating
support components, including the footrest should move together.
c. Release the handle and gently pull on the seating shell to make sure it is locked in the
new position.
d. This adjustment can change the balance of the device slightly so it is good to check
that there is no danger of tipping with the new setting.
K. HIP ANGLE ADJUSTMENT (No recline option)
NOTE -
One or more adjustment limiting collars may be attached to the seating system to reduce the
range of available hip angles. they attach to the mechanical lock shaft. Consult your supplier
and therapist for adjustment needs
.
Adjustment to recline the back and adjust hip angle.
a. Remove the child from the device for this adjustment.
b. Adjust the hip angle by removing the screw that attaches the frame tube to the back-
shell bracket.
c. Position the back to the desired angle, re-insert the screw and tighten.
d. The lower mounting point of the back is provided with a quick release pin to facilitate
folding of the back.
WARNING
Be sure that the attachment screw, and quick-release pin are installed and the back is secure
before using the device.
L. RECLINE ADJUSTMENT (Optional)
WARNING
BEFORE using the recline adjustment, always check that the mobility device is completely
unfolded and in the locked position, and that wheel locks are locked in place. Be careful to
avoid pulling or crimping any life support tubing that may be attached to the child. Always
remember to stabilize the mobility device before performing this action.
•
Rotate the front casters until they point forward.
•
Engage the wheel locks.
•
If equipped with shoulder harness, loosen the shoulder straps to allow room for the
recline.
Recline adjustment
a. Working from the left side of the occupant, grasp the recline adjustment lever (B) while
supporting the shell with your other hand.
b. Squeeze the lever then pull on the back support area. When desired angle adjustment
has been reached, release the handle and gently pull on the seating shell to make sure it
is locked in the new position.
c. This adjustment can change the balance of the device slightly so it is good to check
that there is no danger of tipping with the new setting.
d. If equipped with shoulder harness, re-adjust the straps for proper fit.
23
24
VIII. USE AND MAINTENANCE
24
23
A
B
9921700000 Rev. E
