20
Z I PP I E XP R E SS
H. FOOTBED ADJUSTMENTS
Height Adjustment
Two telescoping tube sections adjust and lock to control footbed height.
a. Identify adjustment screw locations on the rear side of the footbed hanger.
b. Loosen upper screw on each side of the footbed hanger.
c. Slide the footbed up or down to proper height.
d. Tighten both screws.
e. Repeat procedure using lower screw in step 2 if additional range is required.
Angle Adjustment
The footbed has two screws that fit into a series of holes in the footbed sides and two
more that allow footbed rotation.
a. Remove the footbed angle adjustment screw on each side of the footbed.
b. Adjust the footbed to proper angle and align nearest adjustment holes with the
footbed couplers.
c. Install adjustment screws through footbed and into footbed coupler to maintain
proper footbed angle.
Lengthening the Footbed for Maximum Lower Leg Length Adjustment
The foot bed is designed so that the brackets on the ends of the telescoping tubes can be
reversed to add approximately 3 1/2" of leg length adjustment.
a. Remove the footbed from the telescoping tubes by unscrewing the four button head
screws (A) on the inside of the footbed.
b. Remove the screw from each bracket by backing it out far enough to allow the
bracket to slip off the end of the tube.
c. Flip the bracket over and replace it on the end of the tube being careful to align the
screw with the same hole in the end of the tube.
d. Tighten the mounting screw so it goes through the hole and tightens up against
the bracket.
e. Replace the footbed onto the brackets assuring the same angle adjustment is
achieved.
I. PELVIC POSITIONING BELT ADJUSTMENTS
Length Adjustment
a. Remove any belt twists and place the belts outside of the seating area.
b. Engage wheel locks, seat the child, and snap the pelvic positioning belt ends together.
c. Adjust belt length to provide a snug fit. The adjuster is to the child's left.
Position Adjustment
For the standard seat configuration the belt is always adjusted to the rear most point
(approximately 45°). When the contour seat cushion is used, the belt may be adjusted for-
ward to achieve an adjustment of up to 90°.
a. Loosen the attachment screw (B) one or two turns to allow the belt anchor point to
slide in the slot.
b. Move the belt to the desired adjustment position (leave in the rear most position
when the standard seat configuration is used).
c. Tighten the screw.
NOTE -
Install the nylon web strap wraps under the tube, beside the seat base, and back over the top
of the tube. This keeps the belt in the outer most position so it does not interfere with the
seat cushion.
35
38
36
37
IX. DEALER SERVICE & ADJUSTMENT
35
36
37
38
B
A
9921700000 Rev. E
