Zipper Mowers ZI-BTS350, Operation Manual

Page: 29 / 44

TROUBLESHOOTING
Z.I.P.P.E.R Maschinen Austria  www.Zipper-maschinen.at
Betontrennschneider / Concrete cutter ZI-BTS350 Seite 29
17.2.2 Storage
If the machine more than a month is not used, please follow these instructions:
 Entire remove fuel from the tank, fuel cock and carburetor.
 Water from the tap and remove line (this is to do in cold weather after each use)
 Remove spark plug, pour about 1 tablespoon of engine oil into spark plug hole
 Engine switch to the OFF
 Operate starter rope several times
 Spark plug insert
 Generator in a dry, well ventilated place, cover.
18 TROUBLESHOOTING
Trouble Possible Cause Solution
Engine will not start
 ON OFF switch to OFF
 Fuel filter clogged
 Great power tank empty
 Spark plug is defective or loose
 Spark plug gap set wrong
 Switch in the On position
 Fuel filter change
 Fill the fuel tank
 Clean or replace spark plug

Check the correct setting
Motor stoppt kurz
nach Start wieder
 Idle speed too low
 Clogged fuel filter
 The fuel tank is empty
 Adjust idle speed
 Change the fuel filter
 add fuel
Motorleistung zu
gering
 Dirty air filter

Clean or replace air filter
Trennscheibe dreht
sich nicht
 V-belt is defective
 defective clutch
 Change belts
 machine repair
Trennscheibe eiert
 cutting wheel shaft  Check ball bearings , shaft, flange and
nut.
 Replace if defective
18.1 Disposal
Do not dispose of your waste in the ZI-BTS350. Contact your local
authorities for information regarding the available disposal options.
Improper disposal can lead to contamination of soil, ground water soil
seepage of hazardous and noxious substances, and thus reach finally
through contaminated water into your food supply and your health
you gefährden.Wenn replace your old unit with a new one at your
local dealer, is obligated to take back your old equipment free of
charge for the purpose of proper disposal.